Mts SWIFT 50 GLP Sensor Instrukcja Użytkownika Pobierz pdf (Strona 54)

SWIFT 50 GLP Sensors Installation

Road and Track Vehicles

Installing the Transducer

The indicators will flash at a rapid rate for several seconds, then turn

off, indicating the procedure is complete.

C. If the both indicators continue to slowly flash after 2 minutes, or if the

red Fail indicator flashes, there is an error in the zero process. Run

TISTATUS to find out more information. Repeat Steps A and B. If you

continue to have an error, consult the chapter, “Troubleshooting,” in the

SWIFT 50 GLP Sensor Product Information manual (MTS part

number 100-162-722).

D. After completing the Bridge and Angle Zero procedure, rotate the

wheel one full revolution clockwise.

This allows the electronics to locate the index pulse for the encoder.

E. Perform, “Verifying the Quality of the Zero Procedure,” on page 55.

F. Look at your data acquisition system to verify that the SWIFT sensor is

gathering data.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 69 70

Brak uwag

Mts SWIFT 50 GLP Sensor Instrukcja Użytkownika Strona 54