Mts SWIFT 50 GLP Sensor Instrukcja Użytkownika Pobierz pdf (Strona 52)

SWIFT 50 GLP Sensors Installation

Road and Track Vehicles

Installing the Transducer

E. Rotate the tire until the inclinometer reads 0.0°, ±0.1°.

F. Push the Angle Zero button on the front of the TI box. The Angle Zero

indicator will turn on for a few seconds, then turn off indicating that the

Angle Zero procedure is complete.

10. After completing the Bridge and Angle Zero procedures, rotate the wheel

one full revolution clockwise.

This allows the electronics to locate the index pulse for the encoder.

Note The wheel must rotate one-half revolution in the same direction and then

pass over the encoder index point before data collection is started.

11. Perform, “Verifying the Quality of the Zero Procedure,” on page 55.

12. Look at your data acquisition system to verify that the SWIFT sensor is

gathering data.

S50-20

Mounting Screws

Digital Inclinometer

in this position

should read 0°, ±0.1°

Level Bracket

Axes

Icon

Digital Inclinometer

in this position

should read 0°, ±0.1°

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 69 70

Brak uwag

Mts SWIFT 50 GLP Sensor Instrukcja Użytkownika Strona 52