Mts Advantage Wedge Action Grips Instrukcja Użytkownika Pobierz pdf (Strona 27)

Manual Name Operation

Installing a Specimen

The following procedure describes how to install a specimen in the MTS

Advantage Wedge Grips. This procedure assumes a set of wedges has been

properly installed.

The contact area between the grip face and specimen should be as large as

possible.

A small contact area between the grip face and specimen can cause

premature wear to the grip face surface.

MTS recommends that specimens should be machined to provide the largest

possible surface contact area between the grip face and the specimen.

CAUTION

Large contact area

recommended

Small contact area can

cause premature wear

and damage the grips

Wedge face

Contact area

Bottom gap

specification

(3-6 mm)

(H x W)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34

Brak uwag

Mts Advantage Wedge Action Grips Instrukcja Użytkownika Strona 27