Mts Acumen Electrodynamic Test Area Enclosure Instrukcja Użytkownika

MTS Acumen™ Electrodynamic Test SystemTest Area Enclosure Installation Guide100-265-243 A be certain.

20. Align the front door latch.a) Loosen the top and bottom M4 flathead screws located inside the door latch vertical edge.b) Adjust the latch so that

Test Area EnclosureDescriptionItemRear panel assembly1M6 x 1 mm x 35 mm socket low head screw2Top bracket3M6 x 1.00 mm x 12 mm buttonhead cap screw4M6

4. Put M5 C'Bore butt fasteners (item 9) in the two bottom slots in the side panel and insert the DIN912 M5x 0.80 mm x 30 mm SST sockethead cap s

20. Route and secure the safety switch sensor cable.MTS Acumen™ Electrodynamic Test System 13Test Area Enclosure Installation

a) Place the loop clamps onto the sensor cable, and position the clamps near the provided threadedmounting holes on the vertical side edge and bottom

Torque GuidelinesTorque toItem11 N-m (8.2 lb-ft)A10 N-m (7.3 lb-ft)B12 N-m (8.8 lb-ft)C6.5 N-m (4.8 lb-ft)D26. Align the front door latch.MTS Acumen™

a) Loosen the top and bottom M4 flathead screws located inside the door latch vertical edge.b) Adjust the latch so that the upper and lower catch ball

100-265-243 A

© 2012 MTS Systems Corporation. All rights reserved.Trademark InformationMTS is a registered trademark and MTS Acumen is a trademark of MTS Systems Co

ContentsTest Area Enclosure Installation 5About Installing Optional Enclosures...

Test Area Enclosure InstallationTopics:•About Installing Optional Enclosures...

About Installing Optional EnclosuresThe customer must evaluate risks due to ejected parts or materials from the test specimens. If test area guardis n

DescriptionItemFoot mount7M5 X 35MM socket head screw, M5 butt fastener8M5 C'Bore butt fastener9Foot mount10Right side panel assembly11Front door

14. It makes installation easier to route and secure the safety switch sensor cable prior to mounting the sidepanel.a) Place loop clamps over the sens

g) Loop the cable down and back. Plug it into the enclosure switch connector.In most cases where the test area enclosure is installed after frame inst